I checked Drive 0 of my raid 1 (mirror) boot array on the bathroom computer, doing quick/full scans, and optimizing it, and everything came back good. So I put it back in...and it drops about a minute after the rebuild completes. I switched it to a differant slot in my 4 bay hot swap cage, and rebuild. It works fine for ten hours, but then drops in the middle of a backup job with Acronis, along with high CPU usage which causes huge red spikes in my DPC latency checker program. Videos on youtube keeps pausing/freezing as well.
Well now I have it in it's third differant slot, right below drive 1, which seems to be the good drive right now. I'm probably going to get another one, just in case, a bit sooner than I'd planned on. I'd just like to know what the underlying problem is? is it the cable, which I'm going to replace with brand new latched ones, or the fact that I am running them in hardware raid 1 mode and can't run TRIM or the SSD toolbox to optimize them. A bit more hassle than a HDD, but then again, you should defrag those, and I guess TRIM would be an equivalent drawback.
Uptime as of this post is 1 day, 5 hours, and 41 minutes.
No comments:
Post a Comment